Speaker Setup; Digital Setup - Magnat DVS 4232 Mode D'emploi

Speaker Setup:

Downmix
a) LT/RT: you can select this option to decrypt the signal so as to present a vivid theater effect,
provided that your DISC contains PRO LOGIC Dolby stereo effect.
b) STEREO: at 5.1 sound channel output, the audio outputs to 5 speakers and a sub-woofer.
At 2 sound channel output, the audio outputs to left and right speakers.
c) VSS(Virtual circumferential sound): if you play a DISC with 5.1 sound channel mechanism,
the main amplifier outputs virtual circumferential effect.
d) OFF: when select OFF, becomes 5.1 output mode.
Center Delay
This option allows you to set intermission delay time.
Note: available only at 5.1 sound channel mode.
Rear Delay
This option allows you to adjust the setup of circumferential delay time.
Note: available only at 5.1 sound channel mode. Das kann den Suroundeffekt ggf. noch effizienter
gestalten.

Digital Setup:

OP Mode
a) LINE OUT: To zip the inputted signals linearly. The volume is low and, therefore, you should
use this option at nighttime.
b) RF REMOD: Volume is high and is suitable for daytime.
Dynamic Range
You can change the zip mode to LINE OUTPUT in order to adjust linear zip
radio and obtain the zip effects for different signals. If you choose FULL, the peak value of
audio signal is minimum, and becomes maximum if you choose off.
Note: This option is available only when the system is set as "5.1 sound channel".
Dual Mono
This option allows you to set the output methods for the left and right audio
signals. There are 4 modes: stereo, left sound channel, right sound channel, and mixed sound
channel, to be selected according to the AC-3 KARAOKE mode.
Prologic
a) MOVIE MODE: This option allows you to set Dolby Pro Logic II sound mode is movie.
b) MUSIC MODE: This option allows you to set Dolby Pro Logic II sound mode is music.
c) OFF: Turnoff the Dolby Pro Logic II sound mode.
SYSTEM SETUP
- 23 -