System Basic Operation - Magnat DVS 4232 Mode D'emploi

1. ON/OFF
Plug in the power cord to the outlet, switch the MAIN POWER to ON position at the back of the
unit, the unit goes into standby mode, the LED displays "HELLO". Press STANDBY button on the
front panel or on the remote control to start the operation of the system. The system will
automatically detect any input signal. If there is no signal present, the LED will display
" "
NO SIGNAL .
* Note: After shut off the unit, please wait at least 3 seconds before turn on it again.
2. INPUT MODE
The system is not connect the USB or SD memory card:
Press INPUT button on the front panel or on the remote control to cycle through the selections:
OPTICAL 1 --OPTICAL 2 --COAXIAL 1--COAXIAL 2--AUX--TV--USB/SD/MS/MMC input mode.
The system is connect the USB memory card:
Press INPUT button on the front panel or on the remote control to cycle through the selections:
OPTICAL 1 --OPTICAL 2 --COAXIAL 1--COAXIAL 2--AUX--TV--USB input mode.
The system is connect the SD memory card:
Press INPUT button on the front panel or on the remote control to cycle through the selections:
OPTICAL 1 --OPTICAL 2 --COAXIAL 1--COAXIAL 2--AUX--TV--SD input mode.
The system is connect the USB and SD memory card:
Press INPUT button on the front panel or on the remote control to cycle through the selections:
OPTICAL 1 --OPTICAL 2 --COAXIAL 1--COAXIAL 2--AUX--TV--USB input mode. The system
will select the USB input signal preference, then you can press USB/SD button to select the
SD signal.
3. LISTENING MODE
Press LISTEN button on the remote control to cycle through the listening modes:Stereo
--Vocal --Pro-Logic.
4. VOLUME ADJUSTMENT
(1) Master volume adjustment
Master volume is controlled by the MASTER VOLUME +/- button on the remote control or
VOL +/VOL - button on the front panel.
(2) Subject volume adjustment
Press FUNCTION button repeatedly to recycle select subject volume : TREBLE --BASS
--FL --FR --CENTER --SUBWOOFER. Then press MASTER VOLUME button to control
subject volume level up or down.
5. MUTE
Press the MUTE button on the remote control, the system goes into mute mode. Press MUTE
button again to disable the mute mode. The mute function will also be canceled automatically
by pressing the MASTER VOLUME +/- buttons.
6. SELECT SUBWOOFER OUTPUT
To connect an external active subwoofer, connect the monaural input jack of your subwooer
to the SUBWOOFER OUTPUT jack of this unit. If a subwoofer is connected the unit, switch
the SUB. SWITCH at the rear panel in OFF position.
(The system default SUB. SWITCH in ON position.)

SYSTEM BASIC OPERATION

- 20 -