Publicité
Les langues disponibles
Les langues disponibles
Switcher.biling.ii-25
11/4/98 7:58 PM
Adjusting Headset Incoming Volume
1. Adjust the volume by turning the Thumbwheel
on the top panel.
2
3
4
5
2. Try different volume settings. 1 is the
6
quietest and 9 is the loudest.
3. "Make a Test Call" (see page 6) provides
more details about adjusting your
incoming volume.
10
10
e n g l i s h
Page 10
L E A R N T H E B A S I C S
L E A R N T H E B A S I C S
Adjusting Headset Outgoing Volume
1. Outgoing Volume is pre-set. Try making a test
call before adjusting (see page 6).
2. Access the Outgoing Volume Control, remove
the panel on the left-hand side of the amplifi-
er. The same panel houses the
Telephone/Amplifier Compatibility Switch.
3. Use the screwdriver attached to the bottom of
the amplifier to adjust the Outgoing Volume
Control. Turn clockwise to make your voice
louder to the caller. Turn counter-clockwise to
make your voice quieter to the caller.
4. Replace the panel door and the screwdriver.
Adjusting Audio Device Listening Volume
1. Use the Audio Device Incoming Volume
Control on top of the Switcher amplifier.
2. The Telephone/Computer Audio Switch should
be depressed (colored indicator showing).
The Microphone Selection Switch should be in
default position (no colored indicator
showing).
e n g l i s h
2
3
4
5
6
11
Publicité
