Publicité
Les langues disponibles
Les langues disponibles
Switcher.biling.ii-25
11/4/98 7:58 PM
I
P L U G I N T O P O W E R S O U R C E
C O N N E C T T O P H O N E A N D
H E A D S E T
S E T D E FA U LT S E T T I N G S
S E T T E L E P H O N E / A M P L I F I E R
C O M PAT I B I L I T Y S W I T C H
C O N N E C T T O A N A U D I O
D E V I C E
vi
Page vi
S T E P
1. Remove the Battery Access Door located on the
2. Install two AA alkaline batteries and replace the
3. You will hear three "beeps" through the head-
I N S T A L L A T I O N S T E P S
plug into
1
p o w e r s o u rc e
The AC power supply is shown installed and
plugged in to a standard wall socket on the
Installation Overview (see page v).
The Switcher amplifier requires power to work
with most phones.
Power is not required for:
• Lucent Merlin
®
, System 75/85 phones
• Lucent Definity
®
and 8400 series phones
Installing batteries
We recommend an AC power supply (included).
Two AA alkaline batteries (not included) may
also be used, but batteries will need to be
replaced frequently.
side of the amplifier by placing your thumb on the
door and pushing down.
door.
set when the batteries are low.
e n g l i s h
1
Publicité
