i-tec U3CLONEDOCK Mode D'emploi page 9

Quick Start / USB 3.0 SATA HDD Docking Station
Notes:
• Insert the HDD to the docking station carefully and push it
gently and completely against the SATA connector so as to avoid
damaging the connector and so that the HDD is properly displayed
in the OS.
• Do not remove the HDD during the data transfer or during the cloning.
• We recommend reading the manual to your HDD before using it
with the i-tec docking station.
• Insert only 2.5"/3.5" SATA HDD into the docking station, other
devices or objects can damage the SATA connectors or the tilting
strips.
SAFETY INSTRUCTIONS
• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping
and falling to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the
user manual.
FREQUENTLY ASKED QUESTIONS
Available on our website www.i-tec.cz/en/ on the „FAQ" tab of this
product.
EN
9