i-tec U3CLONEDOCK Mode D'emploi page 8

EN
Note: If you insert two HDDs into the docking station at the same time,
you can work with them in a standard way as with other HDDs in the
OS and you can also transfer data between them.
HDD CLONING
1. Before cloning, disconnect the docking station from the notebook/PC.
2. The docking station must be turned ON and the power adaptor
must be connected.
3. Insert the source HDD (Source HDD1) into the docking station
– the red LED HDD1 will go ON.
4. Insert the target HDD (Target HDD2) into the docking station
– it must have the same or higher capacity as the source HDD1
– the red LED HDD2 will go ON.
5. After that you can use the docking station for simple HDD
backup / cloning. Start the backup by double-clicking on the
"CLONE" button (next to HDD2).
6. This will start data transfer from HDD1 to HDD2. The process
is indicated by blue LEDs 25% / 50% / 75% / 100%. When
completed, all 4 blue LEDs will go ON.
8
Quick Start / USB 3.0 SATA HDD Docking Station