Publicité
Les langues disponibles
Les langues disponibles
Flash rate of the red "Error" LED
1
2
3
4
5
6
7
8
9.
Declaration of Conformity
We, Speck Pumpen Verkaufsgesellschaft GmbH, Neunkirchen am Sand,
hereby declare that the device(s) / (machine(s) cited in these operating
instructions satisfy and fulfill the current EC Regulations. The corresponding
Declaration
www.speck-pumps.com
36
Fault description /
System status message
Microprocessor malfunction - Microprocessor restarts
Undervoltage
Temperature too high /
too low
Overcurrent release
Overvoltage
Shaft blocked
Self-test
Motor fault
of
Conformity
Cause / Status
- Supply voltage <180 V AC
- Control activates automatically
- Temperature too high >100°C
- Temperature too low < -20°C
- Current too high
- Internal overcurrent
- Supply voltage >269 V AC
- Load at the shaft too high or
- One or several self-tests
- One or several phases
can
be
downloaded
if the voltage is over 209 V
for more than 6 seconds
protector switched
motor stopped
were not
completed successfully
are not connected
from
our
website:
Publicité
