Receiving A Call - Tait T2000 Série Guide De L'utilisateur

Responding
to calls
Monitor
CTCSS
DCS
RF
squelch

Receiving a Call

To receive calls on a single channel, simply make sure
the radio is switched on and set to the correct channel.
Refer to "Scanning" for information about listening for
activity on more than one channel.
When you receive a call, the radio will unmute and you
will hear the incoming transmission. To respond, simply
lift the microphone off-hook, press the PTT key and
identify yourself.
II
The T2010 and T2015
functions which screen out weak signals and calls
intended for other people.
The table below describes these mutes and how to use
the Monitor (
Purpose:
To eliminate signals
that do not carry your
fleet's identifying
tone or code.
To eliminate signals
that are weaker than
a preset level.
(Switching this off
sometimes improves
reception in mar-
ginal conditions.)
II
are equipped with mute
) key to turn them on and off.
To turn on or off:
Press the Monitor (
briefly.
To turn off, press and hold the
Monitor (
MONITOR indicator flashes.
Press again to restore.
) key
) key until the
English
13