Installation Instructions - Whirlpool XHS1000XX Instructions D'installation

INSTALLATION INSTRUCTIONS

NOTE: Make sure the Adjustable Clothes Rack has the top
and mid poles collapsed into the base pole prior to installing
it onto the washer or dryer.
1.
Determine the installation location
for the Adjustable Clothes Rack
Magnetic
arms
Hold the Adjustable Clothes Rack a few inches away from the
side of the washer or dryer so that the magnetic arms are not
attached to the side of the washer or dryer.
2.
Adjust the pressure plate
Height
adjuster
Turn the height adjuster on the foot assembly clockwise to
lower or counterclockwise to raise the pressure plate. The
pressure plate should just fit under the bottom edge of the
washer or dryer.
3.
Magnetic
Pressure
Center the Adjustable Clothes Rack front to back against the
side of the washer or dryer and slide the pressure plate under
the edge of the washer or dryer. Then tilt the upper part of the
Adjustable Clothes Rack toward the washer or dryer until the
magnetic arms hold it in place on the metal side of the washer
or dryer.
4.
Pressure
plate
adjuster
Once the Adjustable Clothes Rack is centered in the desired
position, turn the height adjuster on the foot assembly
counterclockwise to raise the pressure plate until it is firmly
against the bottom of the washer or dryer. Make sure that
the foot is in solid contact with the floor.
NOTE: The pressure plate needs to press firmly against the
bottom edge of the washer or dryer to avoid movement of
the Adjustable Clothes Rack when the hanger arms are fully
loaded.
You can now extend the top and mid poles, and the hanger
arms can be rotated to the desired location.
Move Adjustable Clothes Rack
into position
arms
plate
Adjust pressure plate
Height
Foot
Pressure
plate
5