EINHELL VIS 250 Instructions De Service page 9

Anleitung VIS 250 Faust 9-spr 06.11.2001 9:20 Uhr Seite 9
Note!
Always wear safety goggles and a
dust mask.
Always keep the dust extraction holes
in the vibrating plate free of dirt or
other obstructions.
Special acessories
Sandpaper
In order to take full advantage of your
vibrating grinder, always use original
special accessories, available at all
hardware shops.
Attaching sandpaper
– Remove the plug from the mains
supply.
– Insert the end of the sandpaper and
close the clamping mechanism.
– Draw the sandpaper tigth over the
vibrating plate and clamp the other
end.
– Make sure the apertures in the san-
ding disk coincide with those on the
oscillating plate
Maintenance
– Always keep your vibrating grinder
clean.
– Do not use caustic cleaning agents
to clean the plastic housing.
– Check the carbon brushes is an
excessive amount of sparks is gene-
rated when working.
– Always keep the dust extraction
holes in the vibrating plate free of
dirt or other obstructions.
– Water must never come into contact
with the machine.
GB
9