Energy Saving Tips; Connecting The Cooler - Dometic Waeco CoolFreeze CF-35 Manuel D'utilisation

_CF-35_60.book Seite 33 Montag, 20. September 2010 10:20 10
6.2

Energy saving tips

Choose a well ventilated installation location which is protected
from direct sunlight.
Allow hot food to cool down first before you place it into the
device.
Do not open the cooler more often than necessary.
Do not leave the lid open for longer than necessary.
Defrost the cooler once a layer of ice forms.
Avoid unnecessary low temperatures.
6.3

Connecting the cooler

Connecting to a battery (Vehicle or boat)
The cooler can be operated with 12 V or 24 V
Warning – Danger of damaging the device!
e
Disconnect the cooler and other consumer units from the battery
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the cooler is equipped with an electronic system
to prevent the polarity reversal. This protects the cooler against
short-circuiting when connecting to a battery.
➤ Plug the 12/24-V connection cable (fig. 1 2, page 3) into the
DC voltage socket and also into the cigarette lighter or a 12 V
or 24 V socket.
Connecting to a 100–240 V AC mains (E.g. in the home or office)
Warning – Danger of electrocution!
e
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
Warning – Danger of electrocution!
e
If you are operating your cooler on board a boat from a mains con-
nection of 100–240 V~, you must install a residual current circuit
breaker between the 100–240 V AC mains and the cooler.
Seek advice from a trained technician.
Operation
.
g
33