S&P TERMOTECH-TS200/03 Manuel D'installation page 9

INSTALLATION
Preliminary operations and warnings
The information in this manual is aimed at all personnel that are exposed to risks. The
objective of the manual is to prevent any personal harm or material damage caused by misuse
or incorrect maintenance. Disconnect the power supply before starting any maintenance
operation.
Before each operation, check that the panel is in perfect condition and not damaged in
any way. If any defect or damage is detected, do not install the apparatus or attempt to
repair it - contact the supplier.
This product should not be used by any person with a physical or sensory disability,
learning difficulties or insufficient knowledge or experience, without qualified supervision.
Children should not be allowed to play with the product.
Do not fit a cable with a radius of less than 50 mm.
Do not touch the panel with wet/damp hands or feet. Do not pull the power cable.
The panels should be installed at a minimum height of 2.5m.
The front surface of the panel should be free from obstruction and uncovered. Failure to
observe this instruction could lead to inefficient functioning, irreparable damage and the
risk of fire.
Ceiling installation
To hang TERMOTECH-TS panels from the ceiling, use the brackets that are supplied.
The brackets are kept in a bag inside the junction box. Remove the
rear fixing screws ONE BY ONE and refit them when the brackets
has been fixed to the side of the panel, as shown in the diagram.
Repeat the operation with the 4 brackets.
To hang the panel, fit the stell chains (not supplied) to the ceiling
and the brackets.