EuroLite T-36 Pinspot Mode D'emploi page 13

Please make sure that there are no obvious transport damages. Should you notice any damages on the A/C
connection cable or on the casing, do not take the pinspot into operation and immediately consult your local
dealer.
This pinspot falls under protection-class I. The power plug must only be plugged into a protection class I
outlet. The voltage and frequency must exactly be the same as stated on the pinspot. Wrong voltages or
power outlets can lead to the destruction of the pinspot and to mortal electrical shock.
Always plug in the power plug last. The power plug must always be inserted without force. Make sure that
the plug is tightly connected with the outlet.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution! Never touch them with wet hands, as this could lead to mortal
electrical shock.
Never modify, bend, strain mechanically, put pressure on, pull or heat up the power cord. Never operate next
to sources of heat or cold. Disregard can lead to power cord damages, fire or mortal electrical shock.
The cable insert or the female part in the pinspot must never be strained. There must always be sufficient
cable to the pinspot. Otherwise, the cable may be damaged which may lead to mortal damage.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the pinspot and the
power-cord from time to time.
If extension cords are used, make sure that the core diameter is sufficient for the required power
consumption of the pinspot. All warnings concerning the power cords are also valid for possible extension
cords.
Always disconnect from the mains, when the pinspot is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord. Otherwise, the cable or plug can
be damaged leading to mortal electrical shock. If the power plug or the power switch is not accessible, the
pinspot must be disconnected via the mains.
If the power plug or the pinspot is dusty, the pinspot must be taken out of operation, disconnected and then
be cleaned with a dry cloth. Dust can reduce the insulation which may lead to mortal electrical shock. More
severe dirt in and at the pinspot should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of the
pinspot. If you suppose that also a minimal amount of liquid may have entered the pinspot, it must
immediately be disconnected. This is also valid, if the pinspot was exposed to high humidity. Also if the
pinspot is still running, the pinspot must be checked by a specialist if the liquid has reduced any insulation.
Reduced insulation can cause mortal electrical shock.
There must never be any objects entering into the pinspot. This is especially valid for metal parts. If any
metal parts like staples or coarse metal chips enter into the pinspot, the pinspot must be taken out of
operation and disconnected immediately. Malfunction or short-circuits caused by metal parts may cause
mortal injuries.
During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily
mean that the Pinspot is defective.
Caution: During the operation, the housing becomes very hot.
Do not switch the Pinspot on and off in short intervals as this would reduce the lamp's life.
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs!
HEALTH HAZARD!
13/33 00026528.DOC, Version 2.1