Publicité
Les langues disponibles
Les langues disponibles
GENERAL INFORMATION
This booklet contains all the necessary information for the installation, use and maintenance of this food-
compatible cutter.
The purpose of this booklet, hereafter the "manual", is to give the user, and especially the operator, proper
information enabling on the necessary cautions regarding the use of this machine and on all the human and
material means that must be implement to make it safe and long-lasting.
These machines have been designed and manufactured to cut in small pieces foodstuffs such as fish,
pulses, cheese, nuts, and others.
This cutter can only be used by suitably trained personnel previous careful reading of the contents of this
manual.
In particular, the following instructions must be respected:
1. install the machine according to the instructions explained in paragraph "Installation";
2. do not remove protections and do not modify nor exclude any of the mechanical and electrical
protection devices;
3. do not use the machine with non-permanent electrical connections or with temporary or non-
insulated wires;
4. in case of defects, anomalous functioning, suspected damage, incorrect movemen, unusual noise,
etc., stop the machine immediately;
5. before cleaning or servicing the machine disconnect it from the mains;
6. always wear scratch-proof protection gloves when cleaning or servicing the machine;
7. entrust any special maintenance to the manufacturer or to duly trained and authorized personnel;
8. do not run the cutter when empty;
9. ventilated motor.
WARRANTY AND MANUFACTURER LIABILITY
Correct functioning and full compliance to the intended service depends on the correct application of the
instructions contained in this manual.
The manufacturer waives any liability, either direct or indirect; deriving from:
1. failure to observe the instructions contained herein;
2. entrusting the machine to non-trained personnel;
3. failure to use this machine in according to the norms currently in force in the country of installation;
4. unauthorized alterations or repair;
5. use of non original accessories and spare parts;
6. acts of God.
PLATES AND CONFORMITY MARKS
All the parts making this machine comply to the requirements of the Directive. Conformity to these
regulations is confirmed by the CE marking on the machine.
The plate bearing manufacturer's identification details, technical data, and UE marking is positioned on the
base of the cutter. This plate cannot be removed and must always be clearly readable.
In case of wear or damage, the user must replace it.
EN
4
Publicité
