Service Programmes; Cleaning The Milk System - Siemens TE 6 Série Mode D'emploi

en

Service programmes

● Thoroughly clean the inside of the appli-
ance with a moist cloth, removing any
coffee residues.
● Allow the brewing unit 14 and the inside
of the appliance to dry.
● Replace the cover 14b on the brewing
unit and then push the brewing unit 14
back into the appliance until it latches into
place.
● Press the eject lever 15 right up.
● Slide the red latch 14a all the way to the
right and close the door 13.
Service programmes
F See also the Quick reference guide in
the storage compartment 16.
Following prior notification, either
Descaling necessary or
Cleaning necessary or
calc'nClean necessary.
appears in display 3 at certain intervals.
The unit should immediately be cleaned or
descaled using the appropriate programme.
The two processes Descale and Clean can
optionally be carried out together using
the calc'nClean function (see the section
"calc'nClean"). Failure to carry out the
service programme according to the instruc-
tions may damage the appliance.
Important: if descaling is not
F
performed on the appliance in good
time, then the following appears:
Descaling overdue. Appliance will
soon be locked --> press menu for
3 sec. Immediately perform the
descaling process in accordance with
the instructions. If the appliance is
locked, it can only be operated again
once the descaling process has been
carried out.
42
F Caution!
For each of the service programmes,
use descaling and cleaning agents
as described in the instructions.
Never interrupt a service programme.
Do not swallow any cleaning fluids!
Never use vinegar, citric acid or any
vinegar-based or citric acid-based
agents. Never place descaling tablets
or other descaling materials in the
coffee drawer 12!
Before starting the service program
(Descale, Clean or calc'nClean) remove
the brewing unit, clean it as instructed and
replace it.
Specially developed suitable descaling
and cleaning tablets are available from
retail outlets or from customer services
(see the section "Accessories")�

Cleaning the milk system

Takes about 1 minute.
● Touch A to open the menu.
● Use I to choose Cleaning and care
and touch B to confirm your choice.
● Use I to choose Rinse the milk
system and touch B to confirm your
choice.
● Touch C to begin running the
programme.
F The milk system can also be cleaned
by pressing E.
The display 3 will indicate the progress of
the programme:
● Place an empty glass under the beverage
outlet 4 and stand the end of the suction
pipe 4d in it.
● Touch C. The milk system will
now clean itself automatically.
● Then empty the glass and clean the
suction pipe 4d.
You should also regularly clean the milk
system manually (dishwasher or by hand).