Fulgor Milano FCH 905 ID TS G DWK Instructions Pour L'installation Et L'utilisation page 44

Automatic heat-up function
When the automatic heat-up function is activated the wattage of the cooking zone is at 100%
for a certain heat-up time which is dependent on the setting selected (continuous).
At the end of the heat-up time the electronic control switches back to the preselected
simmering setting.
GB
Starting process of the automatic heat-up
- The control is ON and a cooking zone will be selected
- When the power level 9 is reached the automatic heating is activated through a further
press of the slider in correspondence with the maximum value.
- The required power level is selected by means of the slider and the selected value is
shown on the display.
- At this point, you can select the level required for the continuation of the cooking using the
Slider area. The symbol "A" appears 3 seconds after the button is released, alternating
with the continuation level.
- The continuation level can be changed within 15 seconds from activation without disabling
the precooking boost. So, you must select the cooking area and then set the corresponding
cooking area.
- If the selection takes place after 15 seconds:
You can select a higher continuation level; this implies that the precooking time will
automatically be aligned to the currently selected continuation level.
Cooking level
0
u
1
2
3
4
5
6
7
8
9
Residual heat indicator
It is meant to indicate to the user that the glass ceramic has a dangerous touch temperature
in the circumference of a cooking zone. The temperature will be determined following a
mathematical model and the remaining residual heat will be indicated by means of "H" on
the corresponding 7-segment display.
Heating up and cooling down will be calculated dependent on
• The selected setting ("0" to "9")
Precooking Boost A [min]
0
0
1
3
4,8
6,5
8,5
2,5
3,5
4,5
0,2
44
Maximum operating time [h]
0
6
6
6
5
5
4
1,5
1,5
1,5
1,5