Fulgor Milano FCH 905 ID TS G DWK Instructions Pour L'installation Et L'utilisation page 56

From 3.3 to 7.1 kW
GB
The surface comes standard with the limiter set to 3.3
kW. It is possible to change from one setting to another
with the following procedures.
Within the first 2 minutes after the last connection
to the mains (new power supply), you can enter the
configuration menu. (if this transition is made after the
surface was already connected to the mains you have
to wait a few seconds in the step of disconnecting and
reconnecting the power supply).
Press and hold the P (Power Booster) key.
At this point the 4 decimal points (.) turn on.
Hold down the P key and press the 4 decimal points in
rotation, starting from the front right.
This operation must be done rather quickly and a
double beep will warn you if the sequence or speed of
execution is not correct.
In the first display above, C-0 will flash intermittently.
Press it until the decimal point appears.
Press the highlighted area of the cursor.
56
P
P
P
P
P
P
P