Fulgor Milano FCH 905 ID TS G DWK Instructions Pour L'installation Et L'utilisation page 47

Setting a timer value
– Adjustment by means of the slider area.
– The adjustment of the first digit usually occurs first, followed by the adjustment of the
second digit.
– Within 10 seconds after setting the second digit, the value might reset (the dot on the timer
display and when there is a specific timer for a hob zone the assigned LED flashing).
– For the display of the active timer, the timer value can be set to [0] by directly pressing [0]
on the slider (left side).
Deactivation of an active timer
– A timer can be deactivated by setting the value to 0.
– An independent timer can be deactivated through the double activation of the power key
(1st TC active, 2nd TC and Timers off).
Independent timer
– If the control unit is activated (the displays of all hob zones show [0]), the independent
timer can be activated by pressing the timer selection key. The display shows 0- and is
ready for setting the first digit of the timer. By pressing the timer display, you can go on
to programming the second digit of the timer. The timer is disconnected after 10 seconds
(blank display) if no other settings are made. If a timer value is set without the activation of
a hob zone within 10 seconds, the displays of the hob zones are also disconnected). The
hot hob zones warning lights [H] are permanently displayed.
– Until the timer is selected (the dot on the display flashes for 10 seconds), it can be set. The
setting range is 0-99 minutes in individual steps, for the Slider area.
– The countdown starts immediately after the timer value has been set, starting from the
last set value.
– The timer is automatically deselected after 10 seconds and the time display indicates the
timer value. Once the set time has expired, an acoustic signal is activated and the time
display shows the flashing symbol "00".
– The beep stops after 2 minutes and/or by pressing any button. Subsequently, the timer
display will stop blinking and switch off. Any hot cooking area warning lights [H] are
displayed permanently.
– By pressing the POWER key, the control unit can be switched at any time from the "sole
timer function" to a hob zone, with or without an active independent timer.If you switch
the Touch Control back to active mode with an independently active timer, first select the
independent timer highlighted by the active selection "-"; in this way you can reset it or
change its value. If you select a cooking area, the "-" on the display disappears and the
time set on the independent timer is displayed. If there is an independent timer set, you
cannot program a specific timer for a cooking area. Once a hob zone has been selected,
the decimal point on the timer display disappears and a decimal point on the hob zone
display flashes. When the control unit is turned off by means of the POWER key, the
independent timer (if functioning still) is also turned off.
47
GB