Publicité
Les langues disponibles
Les langues disponibles
Standard wiring - c/w addressable module
5 5 . . 0 0 O O P P E E R R A A T T I I O O N N
The unit is operated by lifting the spring loaded f ap on the front of the unit, then pulling down the handle
underneath. The pull handle will rotate downwards through 90 degrees. The pull handle will remain latched in the
operated position until manually reset. The lift flap can be lowered back to its original position until the unit needs
to be reset.
The reset the unit, first raise the lift flap away from the pull handle. The key (provided with the unit) is inserted into
the two holes located underneath the pull handle in the front face until resistance is felt. Depress the key further to
release the pull handle which can be returned to its original position. Finally, lower the lift flap back to its original
position.
N N o o t t e e : : When resetting the unit, please ensure the key is depressed centrally with even pressure on each leg of the
reset key.
The operating voltage of the unit is stated on the certification label.
6 6 . . 0 0 M M A A I I N N T T E E N N A A N N C C E E
During the working life of the unit, it should require little or no maintenance. GRP will resist attack by most acids,
alkalis and chemicals and is as resistant to concentrated acids and alkalis as most metal products.
However, if abnormal or unusual environmental conditions occur due to plant damage or accident etc., then visual
inspection is recommended.
If the unit requires cleaning, then only clean the exterior with a damp cloth to avoid electrostatic charge build up.
If a unit fault should occur, then the unit can be repaired by MEDC. All parts of the unit are replaceable.
If you acquired a significant quantity of units, then it is recommended that spares are also made available. Please
discuss your requirements with the Technical Sales Engineers at MEDC.
© MEDC 2014
l
G G E E N N E E R R A A L L A A R R R R A A N N G G E E M M E E N N T T
09/14
Publicité
