Application; Advice On Application; Procedure For Tens, Ems And Massage Programmes 01-10 - Sanitas SEM 40 Mode D'emploi

7. Application

7.1 Advice on application
• If the machine is not used within 3 minutes, it switches off automatically
(automatic switch-off function). When it is switched on again, the LCD
main menu screen appears, with the last used submenu flashing.
• If an admissible key is pressed, there is one short beep. If an inadmissible
key is pressed, there are two short beeps.
7.2 P rocedure for TENS, EMS and MASSAGE programmes 01–10
(quick start)
• From the programme charts, select a programme that is suitable for your
purpose.
• Place the electrodes in the area selected and connect these
to the machine. The corresponding positioning suggestions
may help you here.
• Press the ON/OFF key in order to switch on the machine.
• Press MENU and navigate through the sub-menus (TENS/
EMS/MASSAGE) and confirm your selection with ENTER
(Fig. 1, example of TENS display).
• Using the UP/DOWN keys, select the programme you want
and confirm with ENTER (Fig. 2, example of display for No. 1
TENS programme).
• Using the UP/DOWN keys, select the total treatment time
and confirm with ENTER (Fig. 3, example of 30-minute treat-
ment duration).
The machine is in wait status (Fig. 4).
• Press ON/OFF to start the stimulation treatment. The opera-
tion status display starts to change (Fig. 5).
• Select the pulse intensity which is the most comfortable for
you by pressing the key CH 1+/CH 2+.
The pulse intensity display adapts accordingly.
7.3 P rocedure for TENS/EMS programmes 11 to 20
(individual programmes)
Programmes 11 to 20 are preset programmes which you can also individualise.
Here you can set pulse frequency.
• From the programme charts, select a programme that is suitable for your
purpose.
• Place the electrodes in the area selected and connect these to the machine.
The corresponding positioning suggestions may help you here.
• Press the ON/OFF key in order to switch on the machine.
• Press MENU and navigate through the sub-menus (TENS/
EMS/MASSAGE) and confirm your selection with ENTER
(Fig. 1, example of TENS display).
• Using the UP/DOWN keys, select the programme you want
and confirm with ENTER (Fig. 2, example of display for No.
11 TENS programme).
• Using the UP/DOWN keys, select the frequency you want
Fig. 1
for Cycle 1 (Hz) and confirm with ENTER (Fig. 3). Repeat this
process for all subsequent cycles.
• To terminate frequency setting, set the frequency (Hz) after
the cycle last required "--0" and press ENTER. All frequency
Fig. 2
settings of subsequent cycles are then automatically set at
"0" and thus not taken into account.
i Tip: Hold down the ENTER key for 2 seconds in order to
skip frequency settings and access 'treatment time setting'.
Fig. 3
In the event that you need all 8 cycles, you can also press
ENTER for 2 seconds to terminate selection of frequency
settings.
• Using the UP/DOWN keys, select the desired treatment time
Fig. 4
and confirm with ENTER (Fig. 4, example of 30-minute treat-
ment duration).
• The machine is in wait status (Fig. 5).
• Press ON/OFF to start the stimulation treatment. The opera-
Fig. 5
tion status display starts to flash (Fig. 6).
25
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6