Franke EURO PRO 30 Mode D'emploi Et D'entretien page 9

Upper cabinet or soffit
mountong surface
4. Cut a 1" 1/4 hole for power supply cable. Run wire through hole according the National
Electrical Code or CSA Standards and local codes and ordinances. There must be enough
power supply cable from the fused disconnect (or circuit breaker) box to make the connec-
tion in the hood's electrical box. Use caulking to seal all openings.
Do Not turn on power until installation is completed.
5. Remove hood from carton and set on protective surface.
Vent and electrical openings
and mounting screw locations
EN
Centerline
Power supplì cable hole
in wall
centerline of
exhaust collar
4"
(10.2 cm)
4-5/16"
(11.0 cm)
mounting screws
locations (4)
5-7/8" (14.9 cm)
dia.
centerline
of hood
9-7/8"
(25.2 cm)
13-1/2"
(34.3 cm)
4" 5/16
10-9/16"
(26.8 cm)
13-1/2"
(34.3 cm)
7/8"
(2.2 mm)
9 9