Franke EURO PRO 30 Mode D'emploi Et D'entretien page 11

12. Connect vent system, for either vented or non-vented (recirculating), to hood. Seal all joints
with duct tape.
13. For non-vented (recirculating) installations, install the vent cover, in soffit or cabinet top
vent opening.
14. Make electrical connection:
• Connect the white wire of the power supply
cable with the white lead in the hood using a
twist-on connector; connect the black wire of
the power supply cable with the black lead in
the hood using a twist-on connector.
• Connect the green power suplí ground wire to
the unused, green ground screw.
• Tighten strain relief screws.
• Replace the terminal box cover.
15. Reconnect the power and Reinstall filters.
EN
ELECTRICAL CONNECTION
green
ground
screw
hood wiring
white wires
twist-on
connectors
black
wires
power
supply
cable
1
11
1