8.1
LED-module replacement
LED-module replacement can be done without cut off the luminaire from
mains supply, because an all pole switch will isolate the lampholders
while opening the protective bowl.
Notice: Observe national standards or directions for use which can be
divergent to this!
The LED-module have to be replaced as shown in Fig. 11 and 12.
Fault indicator: KXA-2 .... NE;
(Test during continuous switching of light fitting - combinations with several faults are not registered)
Operation
Mains
Emergency
See the enclosed operating instructions for eBK12, No. 3 2211 00 173, for further information on the function and fault indication.
Explosion protected emergency light fittings
Series: KXA-2 2600 NE, KXA-2 5100 NE
Mains
Mains / Emergency
Mains OFF
Mains ON
LED row of module OFF
LED row of module ON
9.
Disposal / Recycling
When the apparatus is disposed of, the respective national regulations on
waste disposal will have to be observed.
In order to facilitate the recycling of individual components, plastic parts
are provided with the identification mark of the plastic material used.
In case of disposal you can obtain additional information from your
Zumtobel branch.
Subject to modifications or supplement of the product range.
Achtung!
Chemische Beständigkeit beachten.
Nur mit feuchtem Tuch säubern.
Warning!
Do not use chemical cleaner.
Clean with a damp cloth only.
Important!
Attention à la resistance chimique.
Nettoyer uniquement avec un
chiffon humide.
Battery
or
ok
or
ok
VE 12 faulty
VE 12 faulty
ok
Battery low
Lamp fault
Battery fault
LED red - green ON
LED red, - green flashing
LED red, - green OFF
GB
13