ECG CDR 999 DAB Mode D'emploi page 14

Power supply
Before changing or disconnecting the power supply, always make sure that the device is properly
turned off.
1. Check that the local network voltage corresponds to the
values on the type label. Otherwise, contact your vendoror
service center.
2. Place the device so that the electrical outlet is easily
accessible.
3. Plug the power cord in AC INPUT ~ and the other end into
an electrical power outlet. The device is now connected
and ready for use.
4. To switch off the appliance completely, unplug the power cord from the electrical outlet.
When unplugging the device, always pull out the plug from the electrical outlet. If you disconnect
the power cord only from the device and leave it plugged in the socket, small children could be
seriously injured.
Connection of external devices
You can connect an external audio device to the AUX IN connector on the
device using a cable with 3.5 mm connectors (not included).
Using headphones
Before connecting the headphones, lower the volume of the device. After you
connect the headphones, increase the volume until required level. The built-in
speakers will be automatically disconnected after you connect the headphones.
Prolonged exposure to loud music may cause hearing damage. When
using headphones, avoid prolonged listening to loud music.
USING THE SYSTEM
To switch the device to (STANDBY) mode, move the function selector from the position "TAPE(OFF)" to the
required mode AUX, CD/USB or TUNER.
Setting the time
The clock on your radio is automatically set the first time it is used since the time signal was broadcast with
DAB radio stations. If a DAB station is not available, the clock can be set manually via the system menu. (see
the section Clock setting).
Power on / wake up from standby mode
To turn the device on and off:
Press the STANDBY button on the front panel.
•
The display lights up and the device is on. To switch the device to standby mode:
Press briefly the STANDBY button on the front panel.
•
The device then switches off. The clock will be displayed as long as the power is on.
Note: This unit is equipped with an automatic power-off / standby system to save power. This system is
regulated by the EU standard and it is not a DEFECT.
14