Metabo HPT CB 3612DA Mode D'emploi page 17

Loosen
NOTE
Cutting with excessively large spacing between
bearing holders may shorten the life of the band saw
blade or adversely aff ect cutting precision.
4. Guide plate protrusion adjustment
CAUTION
● Be sure to switch power OFF and disconnect the
battery from the body when adjusting protrusion
of guide plate.
In the ordinary operation, protrude the guide plate to
the A side fully.
Loosen two M6 fl at-head screws, then slide the guide
plate and secure it by tightening two M6 fl at-head
screws fi rmly.
When the guide plate strikes against the obstacles
like a wall or the like at the fi nishing of a cut, slide it at
the appropriate position. (See Fig. 13)
A
Hexagonal
bar wrench
(4 mm)
Band saw blade
5. Switch operation (Fig. 14)
Drawing the switch while pressing the switch lock to
either direction indicated by arrow will revolve the band
saw blade while lighting up the LED light.
M8 bolt
Tighten
Bearing
holder
Fig. 12
M6 fl at-head
screw
Guide plate
Fig. 13
After the switch is activated and remains drawn, the
band saw blade will continue revolving even if the
Switch Lock is released.
In addition, the LED light will remain lit.
When you release the switch, the revolution of
the band saw blade will stop and the LED light will
automatically be extinguished in approximately 15
seconds.
CAUTION
Do not look directly into the light from the LED
lamp. Continuous and direct exposure to the
light from the LED lamp can injure your eyes.
LED light
NOTE
○ Using a soft cloth, wipe off any foreign matter that has
adhered to the lens of the LED light, being careful not
to scratch the lens.
Scratches on the LED light may reduce the brightness
of the light.
○ When cleaning the lens of the LED light, do not wipe
with gasoline, paint thinner, etc.
Doing so will damage the lens.
6. Adjusting operating speed (Fig. 15)
CAUTION
Use the band saw blade circumferential speed
setting dial to select the circumferential speed
best suited for the workpiece.
Using a band saw blade circumferential speed
unsuited to cut a workpiece will not only
negatively aff ect cutting precision, but can also
cause damage to the band saw blade.
This unit is equipped with an electronic control circuit
that allows the circumferential speed of the band saw
blade to be freely adjusted.
Prior to operation, use the band saw blade
circumferential speed setting dial to set a mode that
suits the properties, thickness and task conditions of
the workpiece being cut.
English
Switch lock
Switch
OFF
Fig. 14
17