Metabo HPT CB 3612DA Mode D'emploi page 13

3. AC/DC Adapter
Model
Input power source
Output voltage
Operating temperature range
Weight
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are
subject to change without prior notice.
Electronic control
○ Soft-start
○ Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate
causes of overloading.
After that you can use it again.
APPLICATIONS
○ Cutting various types of soft steel materials including
conduit pipes, stainless steel pipes, lining steel pipes
and steel rods
○ Cutting nonferrous metal materials including power
and communication cables and aluminum window
frames
○ Cutting plastic (thermoplastic material cannot be cut
as the band saw blade may become wedged in the
material which is prone to melting when heated by
cutting friction
REMOVAL AND INSTRUCTION METHOD
OF BATTERY OR AC/DC ADAPTER
○ How to install the battery or AC/DC adapter.
Align the battery or AC/DC adapter with the groove in
tool housing and slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 7).
ASSEMBLY AND OPERATION
ET36A
Single phase: AC 120 V 60 Hz
36 V
14°F (-10°C) – 104°F (40°C)
Adapter : 1.8 lbs. (0.8 kg)
Box : 2.6 lbs. (1.2 kg)
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in
a few minutes.
After that you can use it again.
○ How to remove the battery or AC/DC adapter.
Withdraw battery or AC/DC adapter from the tool
housing while pressing the latch (2 pcs) of the battery
or AC/DC adapter (Fig. 7).
Battery
Latch
Pull out
Push
English
Insert
Fig. 7
13