Contraindications; Warnings - ResMed S8 Escape Manuel Utilisateur

Masquer les pouces Voir aussi pour S8 Escape:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

C
ONTRAINDICATIONS
The
S8 E
or certain fault conditions. It should not be used by patients who are dependent on
continuous therapy.
Positive airway pressure therapy may be contraindicated in some patients with the
following pre-existing conditions:
severe bullous lung disease
pneumothorax
pathologically low blood pressure
dehydration
cerebrospinal fluid leak, recent cranial surgery, or trauma.
W
ARNINGS
Read the entire manual before using the
Advice contained in this manual should not supersede instructions given by the
prescribing physician.
A patient should not connect a device to the data communication port unless
instructed to do so by their health care provider or physician. Only ResMed
products are designed to be connected to the data communication port.
Connecting other devices could result in injury, or damage to the
device.
The
by ResMed, or by a physician or respiratory therapist. A mask should not be used
unless the
holes associated with the mask should never be blocked.
Explanation: The
connectors)
mask. When the device is turned on and functioning properly, new air from the
device flushes the exhaled air out through the mask vent holes.
However, when the device is not operating, insufficient fresh air will be provided
through the mask, and the exhaled air may be rebreathed. Rebreathing of exhaled
air for longer than several minutes can, in some circumstances, lead to suffocation.
This applies to most models of CPAP devices.
In the event of power failure or machine malfunction, remove the mask.
The
event of certain fault conditions, pressures up to 30 cm H
*
6
is not a life support device and may stop operating during power failure
SCAPE
S8 E
should only be used with masks (and connectors)
SCAPE
S8 E
device is turned on and operating properly. The vent hole or
SCAPE
S8 E
SCAPE
*
which have vent holes to allow continuous flow of air out of the
S8 E
can be set to deliver pressures up to 20 cm H
SCAPE
Ports may be incorporated into the mask or in connectors that are near the mask.
S8 E
.
SCAPE
is intended to be used with special masks (or
S8 E
SCAPE
recommended
*
O. In the unlikely
2
O are possible.
2

Publicité

Table des Matières
loading

Table des Matières