Assembly Procedures - Qlima PGP 113 Manuel D'utilisation

ASSEMBLY PROCEDURES

Hardware Used
Step 1: pic. 3
•
Step 2.1-2.2: pic. 4
•
Step 3: pic. 5
•
Step 4: pic. 6
•
Step 5: pic. 7
•
Step 6: pic. 8
•
Step 7: pic. 9
•
4
42
Model
Gas type
Countries of des- BE, DK, FIN, FR, IT, NL,
tination (*) NO, SE, SL, LUX
Gas Category I3 B/P (30)
Pressure (mBar) 30
(*) This appliance is not suitable for Germany, Austria, Swiss
Assemble the wheel assembly to the bottom plate. Fix the wheel assembly to
the bottom plate using 4 pcs bolt M6X12 and 4 pcs flange nut M6.
Unscrew the switch button, load small battery, tighten the switch button.
Insert the pins of the base to the holes of lower support, press to secure the
pins. Using 4 pcs screw M5X12 to secure the lower support and base. Insert
the pins of the control box assy to the holes of upper support, press to secure
the pins. Using 4 pcs screw 3/16" screw to secure the upper support and con-
trol box assy.
Assemble block belt. Fix the block belt to the 2 pcs of lower support behind
the front door, using 2 pcs screw M5X12.
Assemble the middle support. Insert the 4 pcs upper support to the lower
support. Secure them with 8 pcs screw 3/16".
Assemble the flame screen to the upper support. Secure the flame screen to
the upper support using 8 pcs screw 3/16".
Assemble the reflector onto the flame screen. Screw the 3 pcs stud on the
flame screen, put 3 pcs washer Φ6 onto the top of stud, then put the reflec-
tor onto the stud, secure them with 3 pcs washer Φ6 and 3 pcs wing nut.
Carefully install the glass tube by lifting up and inserting through the center
hole in the upper plate. Ensure the black silicone ring is attached to the lower
edge of the glass tube as illustrated. Slide the glass tube through the hole of
the lower plate cover and onto the middle plate. Check and ensure that the
glass tube is positioned properly and is completely covering the center hole
of the middle plate.
To aid in installation place black silicone ring on the middle plate and then
install glass tube. Ensure the rim of the glass tube sits firmly in the black sili-
cone ring.
PGP113
propane, butane or LPG only
BE, ES, FR, GB, GR, IT, LUX,
PT, SL
I3+ (28-30/37)
28-30/37