Storch 009ST Traduction Des Instructions D'origine page 66

Spray
Cleaning
Flush gun and clean paint off the outside after each work shift. Store in a dry location.
Refer to your sprayer manual for flushing instructions.
NOTE:
In order to prevent any damage to the pistol parts, do not leave either the pistol or any
other parts in water or solvent cleaning agents. The pistol CANNOT tolerate any strong
cleaning agents, such as cleaning agents containing dichloromethane.
Maintenance and care
In order to avoid injury, please read all warning notice in this operating manual and in
the sprayer instruction manual before performing maintenance work.
Clean/replace filter
1. Perform the pressure relief procedure and actuate the trigger lock.
2. Disconnect the fluid hose from the gun swivel joint.
3. Open the protective clip on the trigger.
4. Unscrew the gun handle.
5. Remove the filter through the top of the handle.
6. Clean filter. Loosen and remove severe deposits with a soft brush.
7. If the filter can no longer be sufficiently cleaned, insert a new filter.
8. Reattach the handle to the gun. Tighten well by hand.
9. Reattach the protective clip on the trigger.
Original instruction 66