Cleaning And Maintenance; Internal Light; Recommendations - NEW POL XS 251 CO Mode D'emploi

14
IIt is also possible to remove
the two thread filters from the
door opening and clean them
(fig. 12).
The filters can be cleaned by
simply placing them under hot
running water.
The condenser should be
The drier is fitted with an inter-
nal light.
To replace the bulb, proceed as
follows:
remove the plug from the
mains socket or switch off
the power supply.
remove the lamp cover.
When drying large items, re-
arrange them during the dry-
ing cycle.
This will help reduce creas-
ing to a minimum.
The washing must be
spun dry before being
SM1733
MAINTENANCE

CLEANING AND MAINTENANCE

15
cleaned two or three times a
year (fig. 13-16).
Open the door, rotate the le-
ver to the vertical position and
remove the cover (fig. 13).
Rotate the 3 levers to the ver-
tical position and remove the
condenser (fig. 14).

INTERNAL LIGHT

17

RECOMMENDATIONS

placed in the drum of the
drier.
While the energy con-
sumed by the spin is mini-
mal, the drying action is
another matter. It is rec-
ommended, therefore,
16
Wash the front and back (fig. 15-
16) and sides of the condenser.
To dry the condenser, rest it on
one side on a towel.
When the condenser is dry, re-
place it following the same pro-
cedure in reverse order.
remove the bulb (fig. 17).
Warning: Do not use bulbs
of rating higher than 15 W!
Replace the lamp cover.
that the washing is spun
dry whenever possible at
the highest possible rpm
or in a separate spin drier.
In this way, the drying
time is reduced with a re-
sulting substantial saving
in energy.
GB
25