Description Of The Electronic Drier; Description Of The Domestic Appliance And Control Panel - NEW POL XS 251 CO Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
GB

DESCRIPTION OF THE ELECTRONIC DRIER

DESCRIPTION OF THE DOMESTIC APPLIANCE AND CONTROL PANEL

1. Condensation water
reservoir.
The condensation is
collected in this reser-
voir when the conden-
sation drain hose is not
connected directly to
the drainage system.
2. ON/OFF button
Switches the drier on
and off, but does not
start the program.
OFF (button released)
ON (button pressed)
3. Dry selection button
for energetic pro-
grams only (cotton/
linen).
Low temperature: deli-
cate
(synthetics) high tem-
perature: cotton and
linen.
WARNING: Pressed:
low temperature.
Not pressed: high
temperature.
4. Condensation drain
button
When the reservoir is
full (the warning light
flashes), position the
programmer on STOP,
when the reservoir is
empty, keep the button
pressed for approxi-
mately 10 seconds.
This will activate the
drain pump to remove
any remaining conden-
sation. On completion,
reset the previously
selected drying pro-
gram.
5. On/Off light
Lights up when the ap-
pliance is switched on
and running. The light
18
7
will flash continuously
on completion of the
drying program, signal-
ling that the washing
fabrics
can be removed from
the drum.
When the light is flash-
ing at the start of a pro-
gram, the program
must be reset.
Place the knob in the
STOP position.
The program can be set
after the audible signal.
An audible signal is also
heard on completion of
the drying program.
6. Temperature indica-
tor light – Electronic
programs:
A. In the energetic
prgrams section,
the light
continuously, sig-
nalling that a high
temperature has
been set.
B. In the delicate pro-
grams section, the
light will be flashing,
signalling that a low
temperature has
been set.
In the timed pro-
grams section, the
light will be
continuously.
The high or low
tem perature must
be set according to
the type of wash-
ing to dry.
The light will go out
during the last
cooling phase.
7. Condensation reser-
voir indicator light
This indicator light
lights up when the res-
ervoir is full. The drier
will stop automatically.
8. Programmer
The drying time is set
by rotating the pro-
will be lit
grammer knob clock-
wise only.
9. Opening the door
Press the right side of
the door (fig. 8) to
open it.
If the door has been
reversed, press the
left side.
8
l i t
SM1733

Publicité

Table des Matières
loading

Table des Matières