Using The Drier; Maintenance; Draining The Condensation Reservoir - NEW POL XS 251 CO Mode D'emploi

GB
AFTER THE END OF A PROGRAM (MECHANICAL MODEL)
Remove the plug from the
mains socket or switch off
the power supply.
Pull the filter upwards (fig 10).
Open it and clean using a
soft brush. Then replace it.
In addition to cleaning af-
DRAINING THE CONDENSATION WATER RESERVOIR
If the condensation drain hose is
not connected directly to the
drainage system, the condensa-
tion is collected in the reservoir
(fig. 11).
The reservoir must be emptied
after each drying cycle.
To empty the reservoir, proceed
as follows:
remove the container from
the drier Fig. 11).
empty the container. The
drain hole is located on the
10
1. Thread filter in the door (fig.
10)
2. Thread filter in the door
opening (fig. 12).
3. Condenser. (fig. 13).
24

USING THE DRIER

ter each drying cycle, the fil-
ter must also be washed
regularly with soapy water
to remove any dust. This will
greatly improve the effi-
ciency of the drier.
NOTE: The required drying

MAINTENANCE

top right.
after emptying the container,
replace it in position and
slide it as far as it will go.
to continue, or start the pro-
gram, repeat the operations
from point "4" (condensation
drain button).
If the reservoir is not emptied
or it fills up during a drying
cycle, the condensation res-
ervoir warning light with light
up and the drier will stop.
CLEANING AND MAINTENANCE
12
Disconnect the drier from
the mains supply before
cleaning.
It is important to clean the
drier after each drying cycle
time depends on:
weight and thickness of the
fabric;
Size of the items;
type of fabric;
degree of dampness of the
washing.
11
Then proceed as described
above.
13
in order to save in drying
time and consequently en-
ergy.
Remove the filter by pulling up-
wards and then clean it. (fig. 10).
SM1733