Publicité
Les langues disponibles
Les langues disponibles
- EN -
Turning the pump casing to achieve a different position
How to proceed:
F
1. Remove the screws for fastening the filter basket and remove the filter basket.
2. Remove the screws for fastening the stand and remove the stand.
3. Remove the four screws for fastening the retaining plate and remove the retaining plate.
4. Remove the four screws and take off the pump casing.
5. Turn the pump casing, place it onto the motor and fasten with the four screws.
– The pump casing can only be mounted in the two positions indicated.
6. Fit the retaining plate onto the pump casing and fasten with the four screws.
7. Place the pump on the stand and fasten with the screws.
8. Fit the filter basket and screw tight.
Connecting the DMX connection cable
A maximum of 31 end devices may be connected to one DMX bus.
How to proceed:
G
1. Remove the protection cap from the unit.
2. Fit the connector of the connection cable and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
AMX0034
Commissioning/start-up
A DMX controller or a DMX/RDM controller can be used for commissioning/start-up and operation.
The DMX / RDM protocol is used for signal transmission and control.
For programming, refer to the controller documentation.
Switching on the unit
Switching on:Establish an electrical connection and transmit the DMX control signal.
Switching off: Transmit the DMX control signal and disconnect the electrical connection.
Addressing via DMX
DMX (Digital Multiplex) is a standardised digital transmission protocol used in stage and event equipment as well as in
many Oase components.
The DMX Channel and the mode can be changed by means of a DMX controller from OASE. Read the corresponding
operating instructions.
Description
Serial No. (SN)
Product ID
Version No.
DMX Channel
Configuration mode
Config. mode
1
20
Note!
The device will be destroyed if water penetrates the DMX/RDM sockets.
Ensure that the DMX/RDM sockets are closed off by the DMX/RDM plug or protection
cap.
Value
Enter the unit serial number. The serial number is indicated on the label next
to the type plate.
125
1
The factory-set DMX channel is indicated on the label next to the type plate.
1 = Set DMX starting address.
Description config. mode
Set DMX channel
Transfer value
Description transfer value
Function
x
Speed
1221
‚
1234567890
V21R-Dy
1234567890123456
1234567890123456
13
x + 0
x + 1
Publicité
