DE
continued. Only switch-off via the ON/OFF button completely switches off
the appliance.
EN
Boiling water can cause scalding. Therefore, please handle the appliance
with care when it contains hot water.
FR
NL
USE - TEA
IT
1.
Pull the lid upward and off of the glass container.
2.
If you want to make tea, remove the strainer as described and fill it with the
ES
desired amount of tea.
PL
3.
Pour in the desired quantity of clean, cold water in the glass container. At
least 0.5 litres water must be poured in, the maximum fill level is 1.5 litres
of water.
4.
Fit the lid onto the glass container without strainer with light pressure. Ensure
that the lid is properly fitted on, and in so doing note the marking on the lid.
5.
Connect the base to the mains supply (220–240 V~, 50/60 Hz).
6.
The red indicator light flashes as soon as the appliance is connected to the
mains supply.
7.
Switch on the appliance via the ON/OFF button.
8.
Select the desired water temperature via the respective button. The
appropriate indicator light lights up. The appliance heats up the water for
hygienic reasons and cools down to the desired temperature.
9.
As soon as the process is concluded a signal tone sounds three times.
10. If you do not switch off the appliance via the ON/OFF button, the appliance
will then keep the water hot for a maximum of 2 hours. As soon as the water
drops below the set temperature the water will be reheated.
11. You can interrupt the boiling process at any time by pushing the ON/OFF
button.
12. Fasten the tea strainer on the underside of the lid by turning it counter-
clockwise and attach the lid to the glass container.
13. Do not pour the tea into the glass container until the water boils to avoid
overcooking.
14. If you want to boil water again, please allow the appliance to cool off for a
few minutes.
15. Boiling water can cause scalding. Therefore, please handle the appliance
with care when it contains hot water.
20 von 68
Copyright UNOLD AG | www.unold.de
Stand 19.2.2020