LaserLiner ClimaData Box Mode D'emploi page 15

1
Inserting battery
Open the battery compartment
and insert battery according
to the symbols. Be sure to pay
attention to polarity.
2
USB drivers / Software installation / Commissioning
1.
You must install the USB drivers before you can start the application
and connect the device to a computer. To do this, insert the supplied
CD in the drive and open the folder entitled "USB Driver". Depending
!
on your Windows operating system version, start the following installer:
32bit version: CP210xVCPInstaller_x32
64bit version: CP210xVCPInstaller_x64
Check the basic information relating to your Windows installation to
see which type of system you have. Follow the installation instructions.
3.
2.
!
The software is only available in English.
Load the CD in the drive and follow the installation
routine. Close the installation program once
installation has been successfully completed.
Then connect one end of the supplied USB cable
to the mini-USB port of the device and the other
end to a free USB port on your computer, and
start the application.
ClimaData Box
EN
15