Quick Start - Pedelec Impulse Xion Mode D'emploi Original

1 Quick start

1. Charge the battery completely before riding for the
first time. Charge temperature: 0°C to 45°C.
2. Remove the cover from the charging socket.
3. Connect the plug of the charger to the battery. When
positioned correctly, the plug is held in the socket by
magnets.
Charging the battery
4. Insert the mains plug for the charger into the socket.
You must fully charge the battery before using it for the
first time.
You can also remove the battery from your Pedelec
and charge it elsewhere. For more information on this
subject, refer to ➠ Chapter 4 "Charging the battery".
5. The charge state of the battery is indicated by five
LEDs. The battery LEDs light up or flash during charg-
ing. Once all of the LEDs have gone out, the battery is
fully charged.
6. If you removed the battery for charging, replace it in
the holder from the front/above. At the same time, the
key must be in the lock and must be turned anticlock-
wise. Press the battery down into the holder until the
locking mechanism engages. Now turn the key clock-
wise and remove it. The battery is now locked in place.
Installing the battery
Locking the battery
Be sure to make a note of the number engraved on
your key. In case you lose both keys, you have an
opportunity to obtain an appropriate replacement key
by quoting the correct number.
VIII User Manual Pedelec Xion 9