weasy TB600 Manuel D'utilisation page 3

• In this case, special care must be taken to ensure that the
fat does not spatter and the heating element overheats
(see section "Solid frying fat" and "Tips").
• Never switch on the deep fat fryer if it is not filled with oil
or liquid fat.
• Only use oil or fat that doesn't foam and is suitable for
frying. This information is shown on the packaging or
label.
• The deep fat fryer must be filled with oil or fat between
the two marks on the inside of the bowl. Before switching
on the deep fat fryer, always ensure that it is filled
withsufficient fat or oil.
• A safety thermal cut-out switches off the deep fat fryer in
the event of overheating (see section "Safety"). These
instructions show the maximum quantities for frying and
must not be exceeded (see table).
• Hot steam is released during frying. Keep a safe distance
away from the steam.
• When the deep fat fryer is in use, it must be kept out of
the reach of children. Do not allow the cord to hang the
edge of a table or work surface on which the deep fat
fryer is standing.
• After use, set the thermostat to the lowest setting (turn
the termostat fully anticlockwise).
• Disconnect the mains plug and allow the oil or fat to cool
down. Do not move the deep fat fryer until it and its
contents have cooled down.
• Damaged parts must only be replaced by an authorized
customer service center.
• The warranty will be invalidated in the case of
unauthorized repairs.
• Please retrain these instructions for future reference.