OHAUS MB23 Guide De L'utilisateur page 5

MB23 / MB25
3. OPERATION
Display
Controls
Button: Name:
Start / Stop
Tare
Temp
Time
There are also several modes of operation which affect how each button operates. Please refer to the following section.
Operating Modes
Standby Mode
When the Analyzer is connected to AC power and the display is off, the unit is in Standby mode.
Start (Short press) Turns on the display and enters Weigh mode.
Print (Long press) Displays the RS232 settings (see Section 6, RS232 Data Connection.). Thereafter,
Set 
(Short press) Switch the RS232 setting between two settings. (see Section 6, RS232 Data Settings.)
Set 
(Short press) Switch the RS232 setting between two settings. (see Section 6, RS232 Data Settings.)
Print (Short press) Re-enters Standby mode (off).
Weigh Mode
The display shows the weight of items placed on the pan support.
Tare (Short press) Sets the displayed weight value to zero
Start (Long press) Enters Standby mode (Off)
The following operations can be initiated:
Temp (Short press) Enters Edit mode for the temperature setting, the value will blink
Time (Short press) Enters Edit mode for the time setting, the value will blink
Start (Short press) Activates Run mode, initiates test with a sample greater than 0.5 g
Cal (Long press) Initiates weight or temperature Calibration (see Section 5, Maintenance)

%
%
g
100°
10:00
Quick Functions:
On (short press) / Off (long press)
Start/Stop (short press)
Back (short press)
Tare (short press)
Enter / Accept value (short press)
Temperature Setting (short press)
Time Setting (short press)
Stable indicator
Percent solids
 Percent moisture
grams
Temperature setting or current chamber temperature (Celsius)
Time setting (minutes : seconds)
Button: Name: Quick Functions:
Increase value
Set 
(short or long press)
Decrease value
Set 
(short or long press)
Print (short press)
Print / Cal
Calibrate (long press)
% g Result Unit (short press)
EN-3