OHAUS MB23 Guide De L'utilisateur page 11

MB23 / MB25
Command
ON
OFF
T
U
START
STOP
P
xP
PSN
PV
?
H
RS
RS:2400,7,N,2,X
RS232 Output
^^^^^^^^^^^^^^^^^^^^^^^^
MOISTURE DETERMINATION
OHAUS MB2x SN #########
Switchoff Mode
Drying Temp
Result Units
00:10 0.0%MC
00:20 0.0%MC
Elapsed Time
Initial Weight
Final Weigh
Final Result
^^^^^^^^^^^^^^^^^^^^^^^^
Compliance
Compliance to the following standards is indicated by the corresponding mark on the product.
Marking Standard
This product conforms to the EMC directive 2004/108/EC and the Low Voltage Directive 2006/95/EC.
The complete Declaration of Conformity is available from Ohaus Corporation
AS/NZS4251.1 Emission, AS/NZS4252.1
CAN/CSA-C22.2 No. 61010-1-04; UL Std. No. 61010A-1
Function
Turns Analyzer ON
Turns Analyzer OFF
Same as pressing Tare
Same as pressing %g
begins a test
ends a test
Same as pressing Print
Interval Print x = Print Interval (1-3600 sec)
Print Serial Number
Print software version
Print Header
Header on or off
Print current RS232 settings
Change RS232 setting (The current RS232 setting can be displayed on the LCD by pressing Print
for 2 seconds while in standby mode.)
Baud:1200,2400,4800,9600,19200
Data Bits: 7 or 8
Parity: N = none, O = odd, E = even
Stop Bits: 1 or 2
Handshake: X = xon/xoff (software), R = RTS-CTS (hardware), N = none
The Analyzer will return "ES" for invalid commands.
All communication uses standard ASCII format.
Sent commands must terminate with a Line Feed or Carriage Return Line Feed (CRLF).
Header on
Header on
TIMED 10:00 Header on
100C Header on
%Moisture Header on
If Print pressed or print interval set.
If Print pressed or print interval set.
00:02:21
Printed at successful end of test.
8.560 g
Printed at successful end of test.
8.555 g
Printed at successful end of test.
0.0%MC
Printed at successful end of test.
EN-9