How To Install The Brush Or Pad; How To Remove The Brush Or Pad - Clarke BOOST 28 Manuel D'utilisation

How To Prepare the Machine For Operation
4. Observe indicator light on the charger to ensure the
charging process has started. Yellow light indicates
state of charge. Steady on green light indicates the
batteries are fully charged.
NOTE: Make sure you plug into a circuit that is not
loaded by other equipment. Wall breakers may be
tripped and no charge will occur.
WARNING: Never charge a GEL battery with
an unsuitable battery charger.
Carefully follow the instructions
given by the manufacturer of the
batteries and battery charger.
NOTE: To prevent permanent damage to the batteries,
avoid their complete discharge. Never leave the batteries
completely discharged, even if the machine is not being
used. When recharging the batteries, keep the recovery
tank open. After every 20 recharging cycles, check the
level of the electrolyte and if necessary top off with
distilled water.

How To Install The Brush Or Pad

To install the brush or pad on the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Press on a brush or pad, under the flex plates. See
figure 15.
NOTE: When using a black pad, position pad on head.
Lower head and operate momentarily to affix pad
to pad driver (if you have difficulty, position pad on
floor and lower head then operate.)

How To Remove The Brush Or Pad

To remove the brush or pad from the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine and pull downward on
the brush or pad until it releases from the flex plates.
See figure 16.
Clarke ® Operator's Manual (EN) - BOOST 28
ENGLISH
EN
Figure 15
Figure 16
- 15 -