Step 3 - Install Door Handles - Haier HRT18RCW Instructions D'installation Et Guide De L'utilisateur

INSTALLATION INSTRUCTIONS
8. Remove the bolts from the bottom hinge and reinstall the
bottom hinge to the opposite side of the cabinet. Tighten
the bolts completely.
A
B
C
9. Unscrew and remove the bottom hinge pin. Reinstall the
pin into the outer hinge hole, and tighten.
A
A - Hinge Pin
10. Move the door stops (bottom of both doors), hinge hole
covers and handle screw plugs, if previously installed, on
both doors to the opposite side of the doors.
A
11. Set the refrigerator door onto the bottom hinge pin. Align
the hinge hole in the door with the hole in the center
hinge. Insert the center hinge pin and completely tighten.
12. Set the freezer door onto the center hinge pin, and then
close the door.
13. Insert the top hinge pin into the hinge hole on the top of
the door. Align the holes in the top hinge with the hinge
holes in the top of the cabinet. Reinstall the hinge bolts
and completely tighten. Replace the top hinge cover.
14. Flip over the base grille and reinstall.
15. Remove door handles (if previously installed) and reinstall
on the opposite side. See "Install Door Handles."
16. Plug in or reconnect power.
49-60778-1
A - Bottom Hinge Pin
B - Bottom Hinge
C - Hinge Bolts
A - Handle Screw Plug
B - Door Stop
B
A
A - Base Grill

STEP 3 - INSTALL DOOR HANDLES

STEP 1 - PLASTIC HANDLES
1. Remove door handles, Haier badge, and screws from the
plastic bags.
door. Slide handle downward to secure it to the mounting
screw (plastic handle only).
NOTE: The mounting screw may need to be loosened
A - Large Handle Screw
3. Rotate door handle toward the gap between the doors.
on the bottom edge of the door and fasten with the two
small screws (provided). DO NOT completely tighten
screws.
5. Repeat above steps to install the handle to the other door.
A
9