Service And Maintenance - Storch Delta Mode D'emploi

SERVICE and MAINTENANCE

Take care not to expose this tool to the rain.
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
Lubrication
All the gears in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under nor-
mal operating conditions, therefore no further lubrication if required.
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided
for the purpose. Contact your local authorities or stockiest for advice on recycling.
Li-ion
Do not dispose of battery packs/batteries into household waste, fire or water. Battery packs/batteries should be colle-
cted, recycled or disposed of in an environmental-friendly manner.
WARNING:
To avoid serious bodily injury remove the battery pack from the tool before conducting any cleaning and maintenance
work.
WARNING:
Only use original spare parts for maintenance work. The use of other parts can be dangerous or result in damage to pro-
perty.
WARNING:
We do not advise using compressed air to clean the Variotool. If compressed air is the only way you can clean the
device, always wear protective goggles or safety goggles with side protection. If a large amount of dust occurs, additio-
nally wear a dust mask.
79 Original instruction