Storch Delta Mode D'emploi page 69

SERVICE
The power tool should be repaired exclusively by a STORCH technician or by a co-operating STORCH service centre.
When servicing a power tool, use only identical replacement parts.
Observe the instructions specified under the "Maintenance" section of this manual. The use of non-approved parts or
non-compliance with the maintenance instructions can result in electric shock or potential injury.
Special SAFETY INSTRUCTIONS for sanding work
WARNING:
Contact with or inhalation of harmful / toxic dusts arising from sanding lead-based painted surfaces, woods
and metals can endanger the health of operator and bystanders.
Take special care to guard against these dusts, including the following: All persons entering the work area
must wear an approved mask specially designed for protection against harmful / toxic dusts, in addition to
using the dust extraction facility, and keeping work area well ventilated.
Unauthorised persons are not permitted to enter the work area.
Do not eat, drink or smoke in the work area. If you suspect the workpiece contains lead seek professional advice.
Some wood and wood type products especially MDF (Medium Density Fibreboard) can produce dust that can be
hazardous to your health. We recommend the use of an approved face mask with replaceable fiters when using this
machine in addition to using the dust extraction facility.
Hold the machine correctly using two hands and adopt a stable stance, make sure that the mains cable is prevented
from coming into contact with the machine or getting caught up on other objects preventing completion of the sanding
pass.
Ensure that you have removed foreign objects such as nails and screws from the workpiece before commencing sanding.
Don't use it for wet sanding, for dry sanding only.
Where possible, secure smaller workpieces to prevent it from moving under the sander.
Do not exert pressure on the sander; guide the tool over the workpiece at an appropriate speed. If you exert too much
pressure and thus reduce the motor speed, you will overload the appliance which in turn will lead to inefficient sanding
and possibly damage the motor.
Do not touch the moving sanding sheet.
Wear protective goggles, wear ear protectors, wear a dust mask !
69 Original instruction