Dometic Waeco CoolMatic MR07 Instructions De Montage Et De Service page 31

CoolMatic MR07, MRR07, MH07
A
NOTICE!
Disconnect the refrigerator and other electric loads from the bat-
tery before connecting the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
For safety reasons the device is equipped with an electronic system to pre-
vent polarity reversal. This protects the device against short-circuiting when
it is connected to a battery.
MR07 and MRR07 only: To protect the battery, the device switches off auto-
matically if the voltage is insufficient (see table below).
Cut-off voltage
Cut-in voltage
7 Using the device
I
NOTE
Before using the device for the first time, clean it inside and out
with a damp cloth for hygienic reasons (see also chapter "Clean-
ing and maintenance" on page 33).
A
NOTICE!
The interior temperature of the device is affected by the ambient
temperature.
 MR07 and MRR07 only: Observe that the set fixed tempera-
ture of 5 °C is fallen below, if the ambient temperature sinks to
below 4 °C.
 Only MH07: Observe that the set fixed temperature of 37 °C
is exceeded, if the ambient temperature rises to above 37 °C.
7.1 Energy saving tips
 Choose a well ventilated location which is protected from direct sunlight.
 Do not open the device more often than necessary.
 Do not leave the door open for longer than necessary.
 MR07 and MRR07 only: Defrost your refrigerator as soon as a layer of
ice forms.
 MR07 and MRR07 only: Clean dust and dirt from the condenser at reg-
ular intervals.
EN
Using the device
11.6 V
12.1 V
31