Dometic Waeco CoolMatic MR07 Instructions De Montage Et De Service page 29

CoolMatic MR07, MRR07, MH07
6.2 Installing the device
➤ Observe the following installation instructions for the place of installation:
– Avoid placing the device next to heat sources such as heaters, gas
ovens, hot water pipes, etc.
– Install the device in a dry, sheltered place.
– The device must be installed so that heated air from it can dissipate
easily. Therefore make sure there is adequate ventilation (fig. 4,
page 4).
No. in fig. 4,
page 4
1
2
3
4
➤ Fix the device with eight screws (fig. 5 1, page 4).
6.3 Removing the transport protection
The device has a locking mechanism to protect it during transport. The fol-
lowing settings are possible (fig. 6, page 5):
 Position 1 (transport lock): (1). The door is locked and secured. To open
the door, turn the bolt to position 2.
 Position 2: (2). The door can be opened.
 Position 3 ("VENT" position): (3). The door is slightly open, but fixed in
position. Use this position, for example, if you are not going to use the
device for a long time.
6.4 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather
than the right.
To change the door hinge, proceed as follows (fig. 7, page 5):
➤ Remove the upper door hinge (1).
➤ Carefully lift out the door.
➤ Remove the threaded pins (2).
EN
Installing and connecting the device
Explanation
Hot waste air
Cold intake air
Condenser
With decorative panel 50 mm space at the top!
29