Dometic Waeco CoolMatic MR07 Instructions De Montage Et De Service page 30

Installing and connecting the device
➤ Pull the locking hook (3) off the rod.
➤ Remove the locking plate (4) and fit it on the opposite side.
➤ Pull the rod downwards and out and put it in the other side.
➤ Fasten the locking hook (3) back on the rod.
➤ Detach the top and bottom lock holders (5) on the left side.
➤ Detach the top and bottom door hinges (1) on the right side.
➤ Fasten the top and bottom door hinges (1) to the left side.
➤ Fasten the top and bottom lock holders (5) to the left side.
6.5 Connecting the device to a battery
The device is operated with a voltage of 12 V DC:
A
NOTICE!
To avoid voltage drops and loss of performance, keep the cable
as short as possible and avoid joins.
For this reason avoid additional switches, plugs or multi-way
adapters.
➤ Determine the required cross section of the cable in relation to the cable
length according to fig. 8, page 6.
Key to fig. 8, page 6
Co-ordinate axis
l
∅
A
NOTICE!
When connecting the battery, observe the correct polarity.
➤ Before starting up the device for the first time, check whether the operat-
ing voltage and the battery voltage match (see type plate).
➤ Connect your device
– as directly as possible to the poles of the battery or
– to a fused socket with at least 15 A.
30
CoolMatic MR07, MRR07, MH07
Meaning
Cable length
Cable cross section
Unit
m
mm²
EN