Description Of Device / Spare Parts; Preparing For Commissioning - ATIKA KSG 220 A Notice Originale

Electrical safety
 Design of the connection cable according to IEC 60245 (H
07 RN-F) with a core cross-profile section of at least

1.5 mm² for cable lengths up to 25 m
 Long and thin connection lines result in a potential drop.
The motor does not reach any longer its maximal power; the
function of the device is reduced.
 Plugs and coupler outlets on connection cables must be
made of rubber, non-rigid PVC or other thermoplastic
material of same mechanical stability or be covered with this
material.
 The connector of the connection cable must be splash-
proof.
 When running the connection line observe that it does not
interfere, is not squeezed, bended and the plug connection
does not get wet.
 Wind off completely the cable when using a cable drum.
 Do not use the cable for purposes for which it is not meant.
Protect the cable against heat, oil and sharp edges. Do not
use the cable to pull the plug from the socket.

Protect yourself against electric shocks. Avoid touching
earthed parts with your body (e.g. pipes, heating apparatus,
cookers, fridges etc.).
 Regularly check the extension cables and replace them if
they are damaged.
 When working outdoors, only use extension cables
especially approved and appropriately labelled for outdoor
use.
 Do not use any defective connection cables.
 Do not set up any provisional electrical connections.
 Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts
of the machine must be carried out by a certified
electrician or one of our customer service points.
Local regulations – especially regarding protective
measures – must be observed.
Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer
service points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user
through the use of other spare parts. The
manufacturer is not liable for any damage or injury
resulting from such action..
14
/

Description of device / spare parts

Position Denomination
1. Rotary table, complete
2. Supporting table
3a/3b. Mounting screw (with spring)
4. Chain stop
5.
Guide plate
6. Guide rail
7. Locking nut
8. Setting screw (for grinding depth)
9. Grinding wheel (100 x 3.2 x 10 mm)
10. Cover
11.
Handle
12. ON-OFF Switch
13. Motor
14. Screw
15. Nut M8, self-locking
16.
Flange
17. Safety label
18. 1 pair of carbon brushes (not shown)
19. Grinding wheel (100 x 4.5 x 10 mm)
20 Protective cover
21. Nut

Preparing for commissioning

 To achieve perfect function of the machine, follow the
notes given in these instructions
You must still do the following:
Mount the rotary table

Set up the device securely

Assembling the rotary table
1. Place the rotary table (1) onto the supporting table (2).
2. Thread the mounting nut (7) on the locking screw.
Mounting the chain sharpener on a workbench
The device must be firmly mounted on a work
surface for safe handling.
Use all three fixing points if possible. But make sure that
the recess for the saw chain remains free and the locking
nut remains accessible.
Hint: We recommend the additional placement of a rubber pad
to reduce noise and vibration (not included in scope of
delivery).
 Place the device at a location that meets the following
conditions:
 secured against slipping
 free of vibrations
 even
 clean and dry
 free of tripping hazards
 adequate light
Order-No.
363702
363730
363704
363705
363706
363707
363708
363709
363710
363711
363712
363713
380026
391037
363715
363716
363717
363718
363720