Surround - Denon AVC-A11SR Mode D'emploi

10

SURROUND

Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with the system setup (see page 14) or from the remote
control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the "Auto" mode and only
effective in the DOLBY/DTS SURROUND and HOME THX CINEMA modes. The adjusted levels for the
different modes are automatically stored in the memory.
1
Press the TEST TONE button.
TEST
TONE
(Remote control unit)
2
Test tones are output from
TUN NG
the different speakers. Use
the channel volume adjust
BAND MODE
buttons to adjust so that the
TUN NG
volume of the test tones is
the same for all the speakers.
(Remote control unit)
3
After completing the
TEST
TONE
adjustment, press the TEST
TONE button again.
(Remote control unit)
• After adjusting using the test tones, make the desired settings for each surround mode to be played, then use
the procedure described below to adjust the levels of the various channels.
1
Press the CH VOL button (or the SELECT
button on the remote control unit) and select
"CH VOL".
CH VOL
ENTER / SHIFT
SELEC
(Main unit) (Remote control unit)
The setting mode switches in the following
order each time the button is pressed.
FL C FR SR SBR SBL
SW SL
FADER
2
Adjust the level of the selected speaker.
UN NG
SELECT
BAND MODE
TUNING
(Main unit) (Remote control unit)
When the surround back speaker setting is set
to "1spkr" for "Speaker Configuration", this is
set to "SB".
2
1, 3
1 2
2
1
NOTES:
• The adjustment range for the different channels
is +12 dB to –12 dB.
• When using the DIRECT mode, the sound from
the subwoofer can be cut by lowering the SW
(subwoofer) setting one step from –12 dB
(setting it to "OFF").
Fader function
• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together. Use it for example to adjust the balance of the sound from the different
positions when playing multi-channel music sources.
1
Press the CH VOL button (or the SELECT
button on the remote control unit) and select
"FADER".
CH VOL
ENTER / SH FT
SELEC
(Main unit) (Remote cont ol unit)
The channel switches in the order shown
below each time the button is pressed.
FL C FR SR SBR SBL
FADER SW SL
2
MAIN UNIT:
Turn the SELECT knob
SELECT
clockwise to adjust the
volume of the surround side
collectively.
Turn the SELECT knob
(Main unit)
counterclockwise to adjust
the volume of the front side
collectively.
REMOTE CONTROL UNIT:
Press the D button to adjust UNING
the volume of the surround
BAND MODE
side collectively.
TUNING
Press the H button to adjust
the volume of the front side
(Remote control unit)
collectively.
The fader function does not affect the SW
channel.
The channel whose channel level is adjusted
lowest can be faded to –12 dB using the fader
function.
If the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values
are cleared, so adjust the fader again.
ENGLISH
1 2
2
1
This is only displayed when setting the fader cont ol.
27