Inner Cleaning; Temperature Setting And Controls - IARP GLOBO RETRÒ Série Instructions D'emploi Et D'entretien

10.2

INNER CLEANING

The storage compartment should be defrosted when frost on the walls has a thickness of more than 5 mm.
We recommend to make the defrosting of storage compartment and, at the same time, the cleaning of displayng
tank; proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature.
2. Unplug the unit.
3. Open the cover and wait for the internal temperature of the tank to be the same as room temperature.
4. Before cleaning the inside temperature must be equal to the ambient temperature; place a container of warm
but not boiling water inside the storage compartment, standing on a piece of cardboard, and leave the door
closed for about 30 min.
5. Remove the plug inside the tank and the external drainage plug;
6. Clean the tanks walls with water and neutral soap, rinse and dry carefully.
7. Plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use jet of water to clean the cabinet: electrical wiring
could be damaged.
Never use mechanical devices or any other means to accelerate
the defrosting process, other than those recommended by
the manufacturer.

11. TEMPERATURE SETTING AND CONTROLS

Each refrigerating appliance is provided with an electronic thermostat (1) for automatic maintenance of
the temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can proceed as follows:
• Press the (˄) key or the (˅) key in order to see on display the temperature set point.
• Press the (˄) key or the (˅) key in order to increment or decrement the temperature set point.
• After 30 seconds, the display automatically reverts to showing the current temperature.
ELECTRONIC CONTROL
-29-