Putting Into Operation; Assembly Of Cover - IARP GLOBO RETRÒ Série Instructions D'emploi Et D'entretien

7.7 PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be
left to stand for at least three hours before being started to allow the lubricating oil to settle in the
compressor. Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the
network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO
BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE GENERAL
EARTHING PLANT.
Follow the manufacturer's instructions to install the unit, using
qualified personnel and complying with the electrical regulations
for the specific country. Incorrect installation may cause injury and
damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to
people or things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law. Absolutely never use reduction units, patch cords,
adapters or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
where it is unilikely to be struck, caught or stepped on, away from water and the other liquids and
heat sources and must not be damaged. In case of breakage of the power cable of the cabinet, it
must be replaced by the manufacturer or by instruction it change of it.

7.8 ASSEMBLY OF COVER

1. Screw in and fasten the supports (A) to the work surface.
2. Insert the two side sections (B) in the supports (A) and tighten the screws.
3. Insert and screw in the brackets (D) in the two side sections (B).
4. Insert the front section (C) in the Supports (A) and tighten the screws.
5. Screw in and fasten the front section (C) to the brackets (D).
A
1
B
B
A
4
B
A
2
D
C
B
5
The cable should be fully extended and located
B
B
3
D
B
D
-26-